To make a realistic bonded bronze TCS recommends the following ratios: (click here for printable PDF)
Product links on this page will take you to our Webstore.
Resin (Polyurethane resin, Epoxy resin, Polyester resin) |
|
For best results: Allow 24 hours cure time past the specific resins demold time before burnishing. |
AquaResin |
|
*Note: 600 parts of metal powder is a starting point. You can add more metal powder than 600 parts as long as the mix remains liquid enough to brush into your mold. |
|
|
For best results: Allow 48 hours cure time after demolding before burnishing. |
Forton MG |
||||||||||||||||||
Click here to purchase Forton MG Kits (FGR not Included)
|
||||||||||||||||||
For best results: Allow 24 hours cure time after demolding before burnishing. |
Winterstone Icing |
|
|
Note: the amount of water may vary slightly with the actual metal to Icing ratio and the kind of metal powder used (Bronze, Brass, Copper etc.) Add just enough water to make the mix "brushable". |
For best results: Allow 3 days cure time after demolding before burnishing. |
HELP! Email Technical Support