A carefully guarded secret of Italian mold-makers for fifteen years, this silicone-based putty is hand sculpted instead of poured, will reduce your mold-making time by 50%, eliminate waste, and enable you to capture incredibly fine detail with molds that are far lighter than anything you can produce now. It is now available in the United States exclusively through The Compleat Sculptor, Inc
RESILPOM is a two-component, room-temperature (RTV), condensation-curing silicone compound. Beginning as a pasty mass, once cured, it becomes a strong molding compound with good mechanical properties and considerable dimensional stability.
Mix RESILPOM (buff colored) with either the regular catalyst (yellow) in a 19:1 ratio by weight (95% base to 5% catalyst)which is included or the fast catalyst (red) in a 50:1 ratio by weight (98% base to 2% catalyst) purchased separately. Mix small quantities to avoid waste from pre-polymerization. Proper mixing has occurred when the color is uniform.This material is ideal for vertical surfaces due to its pasta-like nature. RESILPOM can be applied directly to the model, removed easily and cast in one day. RESILPOM has already been used to reproduce sensitive pieces in the antique and archeological industries. The variety of materials that can be cast into RESILPOM is large, including but not limited to Gypsum, Polyurethane Resin, Wax, Cement, Epoxy Resin, Forton MG, Other Rubbers and Low Temperature Metals.
Approximate cure time (subject to change based on mix ratio and environmental factors):
Slow Cat. about 1 hour. Fast Cat. about 6 minutes.
1kg kit comes with 1 tube of slow catalyst
5kg kit comes with 5 tubes of slow catalyst
25kg kit comes with 25 tubes of slow catalyst
Fast catalyst and extra slow catalysts are available separately
