Ultimate Blood™ Kit

Features

• Quickly make Ultimate Blood™ darker, lighter, more red, less red, etc. using supplied colors.
• Quickly thicken or thin (a little or a lot) based on what you need and change again as needed. Viscosity can range from a very thick gel to very thin. Thin enough to be sprayed (or flowed) without changing color. A single batch can be thickened and thinned multiple times.
• Ultimate Blood™ wets out over skin, silicone and other surfaces without beading up.
• Ultimate Blood™ dries to a wet finish without changing color.
• Dried Blood remains flexible on the skin, silicone and other surfaces without cracking.
• Color washes off of skin and most surfaces and also out of most fabrics.

Instructions

Note: Ultimate Blood™ is not suitable for "in the mouth" use.

PREPARATION... Store and use at 73°F/23°C. Close containers immediately after dispensing. This product has a limited shelf life and should be used as soon as possible. If compatibility or effectiveness for your application is in doubt, a small-scale test is recommended. Humidity – Blood will take longer to dry in a humid environment.

DISPENSING & MIXING... Using Blood Straight – Dispense Blood Base into a small cup or onto a pallet and apply. Adding Thixo, Thinner or Color – For best results, always add a little at a time to the Blood Base to reach desired effect. Mix thoroughly with popsicle stick until desired color and viscosity are attained and apply.

APPLYING... Ultimate Blood™ can be applied in various ways (depending on viscosity) including brushing it on with a chip brush, smearing it on with a popsicle stick or even drizzling or splashing it onto the surface. When the vicosity is thin, it can be sprayed through a dispenser for splatter effects.

DRYING... Drying time depends on ambient temperature, humidity and thickness of the blood being applied. Average dry time is 15 minutes at 1/32” (0.8 mm) thick at 73°F/23°C. Dry time can be accelerated using a hair dryer on a low setting.

CLEAN UP... A heavy layer of dried Ultimate Blood™ can be removed by gently pulling away from the skin. Residual blood can be removed from the skin using hand dishwashing soap and water on a soft cloth. Remove from fabric by applying laundry detergent directly to blood stained area and lightly scrub with a soft cloth until blood shows signs of loosening. Add more detergent and let it penetrate fabric. Soak in cold water and detergent for 30 minutes prior to laundering in a washing machine using a cold water setting.

SDS

TDS