|Availability:||Out of stock|
PC-11 was formulated as a true marine epoxy, allowing users to bond to wet, dry and fully submerged substrates. PC-11 formulation provides extended working time, for large and critical jobs, which allows the user to reposition work or make changes. High wet grab or tack of PC-11 makes overhead and sidewall work easy without drip or sag. PC-11 demonstrates excellent chemical resistance to mild acids, caustics, detergents, gasoline, fuel oil, salt, and fresh water. Bonds most everything to anything. Directions: Using separate knives to remove amount needed, mix equal parts A (white) and B (pale blue) on a flat clean surface until uniform color is achieved. Surfaces to be bonded must be free of dirt, oil, rust, ect. Denatured alcohol can be used to prep the surface. For best results, rough up the surface PC-11 will be bonding to. Normally, no vice or clamp needed. Prop or tape heavy objects to a wall or ceiling. Apply PC-11 in any thickness to both sides of surface and bring together firmly. Be careful to insure that ample PC-11 remains between the contact surfaces. Use screen wire or fiberglass cloth to reinforce large voids and gaps. After cure: Paint Drill, Machine, Sand, File, Tap, or Saw. Note: PC-11 will not bond to wax paper, Teflonï¿½, Polyethylene, and some other plastics. There are hundreds of plastics in thousands of combinations. Test a small area when in doubt.