Protective Coating Company PC-Clear™ Epoxy Syringe 1oz

Article number:	054983070147
Availability:	In stock (2)

Imagine a liquid epoxy that is clear – A liquid epoxy with strength rivaling that of heavy duty paste epoxies – A liquid epoxy that has flexibility and is shatter resistant – A work time of 4 minutes and 1 hour cure time. Imagine NO LONGER!

PC-Clear ™ Epoxy is a medium viscosity liquid epoxy system with greater clarity than other epoxies. This product is excellent for repairs and projects that must be less visible such as art objects or collectibles. PC-Clear™ epoxy is fast curing but allows ample time to apply and position the repair. After curing the epoxy does not become brittle, instead cured PC- Clear™ forms a tough resilient bond. PC-Clear™ can be used on more than just cosmetically critical repairs and in addition it can be used for automotive, construction and facility repairs. Use PC-Clear™ when you are concerned about appearance of your repair and a liquid epoxy is what you are looking for. Work time is about 4 minutes and cures in 1 hour.

Here are just a few specific uses (there are hundreds of other uses):

coverage-chart-pc-clear

Fasten galvanized steel to concrete floor.
Bond sheet metal to wood or masonry.
Seal and insulate electrical connections and electronic boards.

Protect electronic components from vibration and moisture.
Repair porcelain or sculptures.
Reattach multiple broken pieces in a vase.

How to prepare a surface for bonding with PC-Clear™ Epoxy

Remove contaminants such as dust, dirt, oil and grime with a solvents such as Denatured Alcohol (ethanol), Acetone, Rubbing Alcohol (isopropyl alcohol) or Lacquer Thinner. Mild detergent solution in water is also good for removing contaminants.

Use a clean paper towel or rag for wiping. Do not use Mineral Spirits or Paint Thinner for removing contaminants.

Remove rust and loose paint with sandpaper or wire brush. Epoxy typically sticks to most paints. If there is a concern of the paint’s adhesion then remove it with sandpaper, wire brush or paint stripper.

Smooth, glossy and shiny surfaces should be roughened using sandpaper to increase adhesion.

How to clean-up after PC-Clear™ Epoxy application

Clean up mixed epoxy before it cures with paper towels and solvent. Denatured Alcohol (ethanol), Acetone, Rubbing Alcohol (isopropyl alcohol) or Lacquer Thinner are suitable solvents for removing uncured epoxy.

Cured epoxy can be removed with paint stripper or remover.

SDS

Add your review

0 stars based on 0 reviews

Protective Coating Company