|Availability:||In stock (43)|
Brand New! Rock hard finish for all of your outdoor (and indoor) foam projects. This stuff is super tough. It is not sandable. Has a rough stone feel when dry. It can be troweled smooth, or brushed to make a super rough finish.
-Adheres to polystyrene foams.
-Forms a weather resistant surface.
-Easy to mix. Just add water.
-Covers Up to 300 square feet.
-Use above or below grade
-Apply with paintbrush or trowel.
-Many decorative surface textures can be created.
-Soap and water clean-up.
-Try adding Boost fortifier. (will not work with Bounce)
MIXING: Settling may occur in shipping causing a gritty texture that does not stick well. Remix if there is separation in dry mixture. Use when temperatures are between 40°F (4°C) and 100°F (38°C). Mix in a clean container with clean water. Add about 3 parts powder to 1 part water and mix until Foam Coat turns to a smooth paste. A drier mix is stronger. Do not overmix.
APPLYING: If using extruded foam (ie Blueboardor Pinkboard) roughen surface with coarse sandpaper. Fill big cracks and holes by applying pasty mixture with a trowel. You may add more water until mixture is thin enough to apply with a paint brush, although thinning weakens coating. Can be applied with a standard spray hopper. Use thinned mixture to texture large areas. For best strength apply at least 1/4" (6mm) thick. Multiple coats may be applied. Try texturing surface before coating sets.
SET TIME: Use within 30 minutes. Sets up in 1-3 hours. Fogging the surface for 24 hours will increase strength.
FINISHING: Remove dust before painting. This product goes on rough and is not sandable. Finish as the surface is setting up.
CLEAN-UP: Clean tools and brushes with clean soapy water before coating hardens.
WARNING: Avoid prolonged contact with skin. Wear dust, skin and eye protection. Use approved respirator when sanding. In case of eye contact, flush immediately with water, consult a physician. Wash hands with soap and water after use and before eating. Keep out of reach of children.
1/64” thick 36 sq ft
1/16” thick 9 sq ft
1/4" thick 2.25 sq ft
1/64” thick 288 sq ft
1/16” thick 72 sq ft
1/4” thick 18 sq ft
COMPRESSIVE STRENGTH: ASTM C109
1 Day 750 psi
7 Day 2500 psi
28 Day 3500 psi
FLEXURAL STRENGTH: ASTM C348
1 Day 350 psi
7 Day 550 psi
28 Day 1250 psi
Flammability: Noncombustible and not explosive.
Auto-ignition Temperature: Not Applicable
Flash Points: Not Applicable